Packing List - Klipsch ProMedia 2.1 THX Manual De Instrucciones

CAUTION: RISK OF ELECTRIC SHOCK! DO NOT OPEN!
CAUTION! To reduce the risk of electric shock and fire, do not remove the cover or back plate of this device.
There are no user-serviceable parts inside. Refer repairs to a Klipsch authorized service center.
CAUTION! The international symbol of a lightning bolt inside a triangle is intended to caution you to uninsulat-
ed "dangerous voltage" within the device's enclosure.
CAUTION! To prevent electrical shock, match the wide blade of the plug on the power cord to the wide slot on
the power outlet and insert fully.
CAUTION! To reduce the risk of electrical shock, do not expose this equipment to rain or moisture.
CAUTION! Do not plug in the AC cord before setting up your system.
1. Read Instructions. All safety and operating instructions should be read before operating the device and
should be retained for future reference.
2. Heed Warnings. All warnings on the device and in the operating instructions should be adhered to.
3. Water and Moisture. The device should never be used in, on or near water due to the risk of fatal shock.
4. Wall and Ceiling Mounting. The device should be mounted on a wall or ceiling only as recommended
by the manufacturer.
5. Ventilation. The device should always be located in such a way that it maintains proper ventilation. It
should never be placed in a built-in installation or anywhere that may impede the flow of air through its
heat sink or ventilation openings.
6. Heat. Never locate the device near heat sources such as a radiator, floor register, stove or other
heat-generating device.
7. Power Supply. The device should only be connected to a power supply of the type described in the
operating instructions or as marked on the device.
8. Power Cord Protection. Power cables should be routed so they are unlikely to be stepped on or crushed by
items placed on or against them. Pay special attention to where the plug enters a socket or fused strip and
to where the cord enters the device.
9. Periods of Non-Use. The device should be unplugged from the wall outlet when it is not in use for
extended periods.
10. Dangerous Entry. Care should be taken that no foreign objects or liquids fall or are spilled inside
the device.
11. Damage Requiring Service. The device should be serviced by an authorized service center when:
• The plug or power supply cord has been damaged.
• Objects have fallen or liquid spilled inside of the device.
• The device has been exposed to moisture.
• The device does not appear to be operating properly or exhibits a marked change in performance.
• The device has been dropped or the cabinet has been damaged.
12. Service. The user should not attempt to service the device beyond what is described in the operating
instructions. All other servicing should be referred to qualified personnel. For U.S. customers, if dealer
service is not available, contact Klipsch customer service for a return authorization (RA) number before
shipping. Klipsch Customer Service: 1-888-554-5665. If purchased outside of the U.S., please contact
your local dealer or distributor.
P A C K I N G L I S T
2 Satellite speakers with pedestals attached
1 Control pod, attached to one satellite speaker
1 Subwoofer
1 Packet of two individual speaker connections
1 Owner's manual packed with rubber isolation feet
S P E A K E R P L A C E M E N T
1. Attach the supplied rubber feet to the bottom of all loudspeakers.
2. The two satellite speakers should be positioned on each side of your computer monitor. To wall mount, the
pedestal stands may be removed by unscrewing the 1/4" 20-thread bolt, which accommodates a wide
variety of wall brackets available through stereo and appliance stores. Klipsch WB-1 wall brackets are
available at www.klipsch.com.
3. Locate the subwoofer either directly under your computer desk, or close to the satellite speakers. Do not
cover up the side sub driver or front port of the enclosure and be sure to provide enough ventilation to the
rear of the subwoofer. It is normal for this panel to be warm to the touch. The subwoofer should be no clos-
er than 10" to the computer monitor to avoid interference.
4. Speaker or power cables running across an area of heavy foot traffic should be positioned against a wall or
corner and secured with tape.
S O U N D C A R D CO N N E C T I O N
1. Plug the ProMedia 2. 1 control pod input cable into the soundcard output jack on the rear of the PC. Since
the Klipsch ProMedia 2. 1 has its own internal amplifier, it was designed to hook into the line out connector.
Connection to the speaker level output jack might result in poor sound quality.
2. Connect the control pod output, which is the round multi-pin plug, into the subwoofer "Preamp Input."
3. From the subwoofer, connect the two remaining individual speaker wires to each of the two satellites. Be
sure to observe proper polarity (+/-) for the tinned wire ends that connect to the subwoofer.
S P E A K E R CO N N E C T I O N D I AG R A M
1
4
1. Connect mini plug to PC soundcard from the control satellite preamp.
2. Connect the DIN plug to the subwoofer from the control satellite preamp.
3. Connect the speakers by inserting the tinned wire leads into the subwoofer.
4. Do not plug in the AC power until your computer system is set up.
5. Plug headphone mini stereo plug in headphone jack, if desired.
6. Plug stereo mini plug into MP3/Aux jack. Plug stereo mini plug into MP3 player (as an example).
S O F T WA R E A N D H A R DWA R E G A I N CO N T RO L S
Software Volume Controls in Microsoft Windows
1. Click the Start button on your taskbar
2. Choose Accessories
3. Windows 95: Choose Multimedia
Windows 98: Choose Entertainment
4. Click on the Volume Control
5. Adjust the Wave Volume Elevator Button to halfway
Volume Control Programs
Some soundcard and/or PC manufacturers may have software that must be adjusted separately from the
Windows volume control. Consult applicable manual for specific hardware documentation.
Subwoofer Level
For CD or DVD output, the optimum position will be indicated by the mark at 10 o'clock on the sub level con-
trol. Optimum sub levels and user preference may vary from game to game. Usually a high bass level is pre-
ferred, especially at low listening levels. Remember to reset the control settings before playing CDs or films on
DVD.
3
2
5
230 V
6