RADIOMODE________________________________
Antennas
1
For FM stations (VHF) extend the telescopic antenna.
Note:
If the FM signal is too strong, it is advisable to push
7
in the telescopic antenna.
Selectingtheradioinputsource
1
ON/OFF
Press the
button briefly to power on the
device
2
Move the »Bluetooth/CD/USB/RADIO« switch
to the »RADIO« position.
Settingandstoringradiostations
Automatictuningstation(ATS)
1
Activate the ATS by pressing
button until the frequency display changes to rapid
run through.
–The device searches for up to 20 radio stations
and then saves them. After the search has finished,
the station stored in position 01 can be heard.
Automaticstationsearch
1
Activate the station search by pressing
or
»UP
« until the frequency display changes to
rapid run-through.
– The search stops when a station is found.
Manualstationsearch
1
To move the frequency backward/forward in steps,
briefly press
»DOWN
– The frequency changes in steps of 50 kHz.
24
ENGLISH
PROG/MEM/STOP
»DOWN
« or
»UP
« several times.
Storingstationsonstationpositions
Up to 20 stations in the FM band can be stored.
1
Press
»DOWN
2
Press »PROG/MEM/STOP« button briefly to acti-
vate the memory function.
3
Select the desired station position with
»ALBUMMEMORYUP« or
»ALBUMMEMORYDOWN«.
4
Press »PROG/MEM/STOP« button again to save
the station
5
To store more stations, repeat steps
Note:
You can replace a station on a preset with a new
7
one by carrying out steps
above.
Selectingapresetposition
1
Select the station preset position with
ORY/UP« or »ALBUM/MEMORY/DN«.
Stereo/monoreception
«
If the device receives an FM stereo station, »
pears in the display. However, if the signal from the FM
stereo station is weak, you can improve the sound qual-
ity by switching to mono reception.
1
Switch to mono reception by pressing
»MODE/MONO/ST.«.
2
Switch to stereo reception by pressing
this button again.
« or
»UP
« to select the station.
1
to 4.
1
4
to
as described
»ALBUM/MEM-
« ap-
)