Publicidad
Step 13
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the diagrams. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the RIGHT DOOR (L) with CURVED HINGES to the RIGHT
å
UPRIGHT (E). Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten the RIGHT DOOR (L) with STRAIGHT HINGES to the RIGHT
å
END (A). Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Repeat this step fastening the LEFT DOOR (N) to the LEFT END (B).
å
Fasten a PULL (128K) to each DOOR. Use two SILVER 1/4" MACHINE
å
SCREWS (61S) and two WASHERS (10I) for each PULL.
Peel the FELT DISC from the FELT DISC CARD (1M). Stick a
å
FELT DISC on the DOORS where they come into contact with
the UPRIGHTS (E and F).
Insert the DOOR STOP (4I) into the hole in
å
the LEFT UPRIGHT (F).
See the next step for
å
DOOR adjustments.
B
Page 18
E
F
4I
419142
Stop
Mounting
screw
Stop
Mounting
screw
A
10I
L
10I
(6 used)
14H
Curved Hinge
13H
Straight Hinge
61S
SILVER 1/4" MACHINE SCREW
(6 used for the PULLS)
128K
L
(3 used)
1M
www.sauder.com/services
Publicidad
