Meta System DEF-COM 3 Manual Del Usuario página 17

RESTORING THE DEFAULT OVERRIDE CODE
Should the driver forget or lose the override code for the product, the '11111' default override code can be restored provided he has two
remote controls. Follow the procedure below to do this:
Disarm the product using the remote control, turn the motorcycle's ignition key to ON and press button A alternately on both remote
controls twice. The siren confirms that the override code has been restored by means of its Beep-Beep-Boop-Boop sequence, and the
LED then displays the code 11111. All the actions requiring use of the override code can now be completed since it has been confirmed.
ADDITIONAL REMOTE CONTROLS
EN
The alarm system is usually supplied with 2 remote controls, called nr. 1 and nr. 2.
It is possible to check how many remote controls are programmed into the alarm system's central unit every time the motorcycle is
switched off (i.e. when the ignition key is turned OFF): the LED flashes the same number of times as the number of remote controls.
To add or remove remote controls from the memory, gather all the remote controls together that are to be included in the alarm system's
memory (new remote controls must be programmed at your dealer's with the code on the red code-card that is supplied with the
product) and proceed as follows:
1. disarm the alarm system
2. turn the ignition key ON for 3 times within 5 sec and keep it ON the last time (a BEEP sound confirms selection)
3. turn the ignition key OFF within 5 sec and insert the 'override' code
4. when the fifth digit is confirmed, keep the ignition key ON: a series of BEEP–BEEP-BOOP-BOOP sounds confirms the code was correct
5. briefly press the button A of the remote control to be included: the LED flashes to confirm reception
6. press the button A of the same remote control again: a BEEP sound the LED switching OFF confirms it has been memorised
7. repeat steps 5 and 6 for all the remote controls to be included. Any remote controls that are not used (e.g. if lost) will be excluded.
8. turn the ignition key OFF a series of BEEP–BEEP-BOOP-BOOP sounds confirms the end of the procedure and the LED flashes the same
number of times as the number of included remote controls.
17