Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
• The protective grill on the front of this
heater is coated with a special high-
temperature resistant paint. When the
heater is used for the first time, the
grill may give off noticeable smoke
or fumes. This is normal and will not
occur during subsequent uses. The
fumes are not harmful.
• Operating time will vary depending
on the heater setting and the supply
cylinder size. Up to 1.5 to 3.5 hours
on a 1 lb. cylinder. Up to 36 to 72
hours on a 20 lb cylinder (based on
"HI" and "LO" settings). Due to the
properties of LP gas, runtimes can be
significantly reduced when operating
continuously at temperatures
below 20ºF. Use of a 20 lb. tank is
recommended in these conditions.
NOTE: For burn time of an accessory,
refer to the accessory manual.
• When moving heater when lit or
bumping heater setting it down, the
tip over switch may shut off heater. If
this happens, re-light.
• Due to natural operation of small
tanks, condensation may build up on
tank and drip on surface under heater.
HEATER LIGHTING /
OPERATING INSTRUCTIONS
FOR USE WITH DISPOSABLE 1
LB. PROPANE CYLINDERS:
ALWAYS ATTACH OR DETACH
CYLINDER OUTDOORS AWAY FROM
FLAMES, OTHER IGNITION SOURCES,
AND ONLY WHEN HEATER IS COOL
TO TOUCH. NEVER SMOKE WHEN
ATTACHING OR REMOVING PROPANE
CYLINDER OR MAKING REMOTE
CONNECTIONS!
• The LP-gas cylinder(s) used must be
constructed and marked in accordance
with the specifications for LP-gas
cylinders of the U.S. Department of
Transportation (DOT).
• Use only VAPOR WITHDRAWAL
propane supply. If there is any
question about vapor withdrawal, ask
your propane dealer.
• Use only 16.4 oz. (1 lb.) disposable
cylinders that mate with No. 600 valve
connection.
• This heater consumes oxygen from the
room in which it is installed. To assure
complete combustion, an adequate
fresh air supply to the room, See
General Safety Instructions, Page 3.
• Heater and attached cylinder must
be in an upright position during
operation.
IMPORTANT: The heater must not be
exposed to flammable vapors or liquids
during lighting.
1. Make sure control knob is in "OFF"
position. See Figure 1.
2. Swivel regulator at the rear of
the heater outward for easy tank
installation. Screw 1 lb. disposable
LP-gas supply cylinder clockwise (from
bottom) into portable heater until
hand-tight. See Figure 2. Do not use
thread sealant on this connection.
3. Check cylinder connection for leaks
with soapy water at the threaded
connection under the domed plastic
cover where the cylinder screws into
the regulator. DO NOT USE ANY
EXPOSED FLAME TO CHECK FOR
LEAKS. DO NOT OVERTIGHTEN. SEE
WARNING! ON DOMED PLASTIC
COVER.
4. Push control knob down slightly and
rotate counterclockwise to Heater
"Ignition/PILOT" position. See Figure 3.
5. Push and hold control knob down
while holding down ignition button
until pilot is lit. See Figure 4.
6. Release ignition button and continue
to hold down control knob down for
30-60 seconds and release. (If pilot
does not sustain flame, return to step
#4.
7. With pilot lit, push control knob down
and rotate to LO/HI setting position.
Shutdown Instructions
1. To shut off heater, slightly push down
and turn Control Knob clockwise to
"OFF" position.
• Do not operate, store or remove
cylinder near flammable items or
ignition sources.
LP-GAS CYLINDERS MUST BE
DISCONNECTED FROM HEATER WHEN
NOT IN USE!
Mr. Heater | Portable Buddy Radiant Heater
Ignition Button
5
Operating Instructions and Owner's Manual
Ignition
Pilot
LO
ACC
ON
HI
Figure 3
Figure 4
Acc
Ignition
Pilot
Publicidad
