CenturionPro MINI Manual Del Propietário página 5

For optimal performance and life, the BED BAR BLADE must be removed then cleaned every few
hours of operation.
Remove
3/32" Bolts
Loosen Only
CLEANING
For optimal performance and life, the components must be cleaned every 3 to 4 days of use.
Instructions:
Clean with pressure-washing at 1500-2000
PSI, Hot Water, Fan Spray Setting
Run the CenturionPro for 15 minutes after
washing, allowing components to dry
Avoid water contact on bearings
Clean the Brush using
pressure washer
Pivot the PIN up
from the BLADE
Remove the BED BAR
BLADE the MAGNET
BAR carefully!
2.) Remove
MAGNET BAR
MAGNET
1.) Slide BLADE off
MAGNETS
Installation is reverse order of Removal
Clean the length of the
CUTTING REEL and
SHROUD of
all debris
Clean BED BAR BLADE and MAGNET
BAR with utility knife. Wipe clean with
acetone
Avoid water
on the motor