Publicidad
Idiomas disponibles
Idiomas disponibles
3. See Figure 648611l. Tighten cone until the jaws are locked securely behind
the bearing or seal, etc. Position the weight on the slide hammer body until
it is against the cone. See Figure 648611m. Move the weight rapidly to the
rear sharply to remove the bearing, seal or gear.
4. Outside pulls are similar, except the position of the puller jaws should be
reversed and the cone should be installed with the convex surface facing
the puller jaws.
Axle Pulling - Front Wheel Drive Vehicles
1. Axle shafts may be pulled from the transaxle of front wheel drive vehicles
using the box-like axle shaft puller attachment. In the tool case this tool is
labeled "FWD Axle Puller Adapter". To use, drain transaxle.
2. Remove front hub and disconnect axle shaft using hub puller as outlined in
manufacturer's vehicle servicing information. See figure 648611n. Retain
the axle nut for later use.
3. Make sure any snap rings or bolts that may hold axle shaft into transaxle
have been removed. Install the axle shaft attachment by guiding the end of
the axle shaft through the provided hole in the axle shaft attachment.
4. Thread the axle nut removed earlier onto the end of the axle shaft. See
figure 648611o. Thread the slide hammer into nut welded to the axle shaft
attachment. See figure 648611p.
5. Move the weight on the slide hammer body to the rear sharply to pull axle
shaft from transaxle. Note that transaxle may leak fluid once axle shaft is
removed and have a suitable container ready to catch fluid if necessary.
Other Uses - The Master Axle Puller Set Kit contains a large slide hammer and a finger hook, tapping screw, threaded adapter and tapping screw adapter that make it useful for
general use as a slide hammer as well as an axle puller. In the tool case these tools are labeled "Hook", "Threaded Adapter", "Tapping Screw", and "Adapter".
Bodywork: Slide hammer may be used for pulling dents from fenders, etc. Drill a small hole through the metal inside the damaged area. Install the tapping screw into the
adapter and thread the adapter onto the slide hammer. Thread the screw firmly into the hole. It may be necessary to turn the entire slide hammer assembly to do this. See
figure 648611q and 648611r. Move the weight on the slide hammer body to the rear sharply to pull dent outward. Drill additional holes and repeat process until desired result is
achieved. Another body work option is the provided finger hook style puller, which can be hooked over the edge of damaged body parts and pulled with the slide hammer. See
figure 648611s.
Gear Pulling Using Puller Arms & Yoke - Front & Rear Wheel Drive Vehicles
Slide hammer may be used for pulling gears by using the puller jaws and yoke. Generally follow the procedures listed for pulling seals and bearings, but where the instructions
require attaching the puller jaws to a bearing or seal, instead place the jaws around or behind the gear.
Figure (k)
Figure (l)
Figure (o)
Figure (p)
2
Figure (m)
Figure (n)
Figure (q)
Figure (r)
Figure (s)
Publicidad
