Outside Mount - Levolor Fabric Instalación

Ocultar thumbs Ver también para Fabric:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: The brackets must be flush against
a flat mounting surface. Do NOT mount brackets
on curved molding.
Center the headrail over the window
opening at the desired height.
Mark screw locations for each L bracket
approximately 3" from end of cassette,
2 holes per bracket.
— Use a level to ensure all brackets will be in alignment.
If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart.
STEP 2: INSTALLING THE BRACKETS
Pre-drill screw holes using a
using pencil marks as a guide.
— If installing brackets into wood,
used supplied screws.
— If installing into drywall, use
anchors in combination with
supplied screws.
Screw in L brackets at marked
locations, 2 screws per bracket.
Ensure all brackets are square with each other.
Attach cassette mounting bracket to L bracket using screws and wingnuts.
— Make sure the release tab is always mounted on the bottom.
STEP 3: INSTALLING THE SHADE
Hook the top, middle rib of the cassette
valance onto all of the bracket hooks.
Rotate the back of the cassette valance
firmly upwards and toward the window
until the groove at the bracket snaps
into place.
CAUTION: Be sure the bracket and headrail are properly secured
!
before operating the shade. Failure to do so may result in the shade
falling and possible injury.
10
Continuous Cord Loop Lift Control–Cassette Valance
Bracket
Bracket
" drill bit,
1
16
Drywall
Anchors
Drywall
Anchor
Screw
Screw
Bracket
Bracket

Publicidad

Tabla de contenido
loading

Productos relacionados para Levolor Fabric

Este manual también es adecuado para:

SolarBanded

Tabla de contenido