Commercial Electric 56513241 Guía De Uso Y Cuidado página 6

installation (continued) installation (continued)
5
Attaching the housing to the ceiling
□
Drill a 1/8-in. pilot hole into each of the screw locations marked on the ceiling. You can also use an awl or
nail to dimple the screw holes.
□
Install a drywall anchor (BB) and a mounting screw (CC) in each drilled mounting hole, but do not tighten
fully.
□
Align the 4 mounting keyholes on the fixture housing (A) with the 4 mounting screws (CC) in the ceiling.
once the screw heads are through the large ends of the keyholes, slide the housing (A) until the heads of
the mounting screws (CC) slide into the narrow ends of the keyholes.
□
Finish tightening the mounting screws (CC) until the fixture
housing (A) is tightly secured to the mounting surface.
nOTe: The drywall anchors (BB) are
only to be used for mounting the fixture
to plaster or drywall surfaces.
nOTe: If the electrical connection
wires go through the middle knockout
hole, just mount the fixture to the
electrical box using the two electrical
box screws (DD).
6
Attaching the diffuser to the housing
□
Place the diffuser (B) onto the housing (A) and push down gently on each end.
□
Slide the diffuser (B) to one end cap of the housing (A) and reinsert the clip on other end cap of the housing (A).
□
Restore power to the electrical box.
□
Turn on the light switch to activate the fixture.
BB
CC
A
6
End Cap
Clip
B
Clip
A