Tools Required; Removing The Old Door - Wayne Dalton 8000 Manual Del Usuario

Tools Required

Pencil Ratchet wrench Vice grips Gloves
Power drill
3/8", 7/16" Socket driver
Safety glasses Hammer
Phillips Head 1/4", 3/8", 7/16", 1/2" &
7/16", 1/2", 5/8" & 9/32", 1/2", 3/16" & 1/8"
Screwdriver 9/16" Wrenches
9/16" Sockets Drill bits
Level Tape measure Vice clamps
Sawhorse
Flat tip screwdriver
1/4" Tamper resistant torx bit
3" Extension
Step Ladder
Removing An Old Door
IMPORTANT: COUNTERBALANCE SPRING TENSION MUST ALWAYS BE RELEASED BEFORE ANY ATTEMPT IS MADE TO START REMOVING
AN EXISTING DOOR.
WARNING
A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INJURY. TO AVOID
INJURY HAVE A TRAINED DOOR SYSTEMS TECHNICIAN, USING PROPER TOOLS AND INSTRUCTIONS, RELEASE THE
SPRING TENSION.
For detailed information see supplemental instructions "Removing an Existing Door /Preparing the Opening". These instructions are
available at no charge from Wayne Dalton, a Division of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH 44660, or at www.
Wayne-Dalton.com.
5
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.