Gaggenau 400 Serie Manual De Instrucciones página 17

through an exhaust gas system (e.g. a chimney).
With the extractor hood switched on, air is extracted
from the kitchen and the adjacent rooms. Without an
adequate supply of air, the air pressure falls below
atmospheric pressure. Toxic gases from the flue or
the extraction shaft are sucked back into the living
space.
Always ensure adequate fresh air in the room if
▶
the appliance is being operated in exhaust air
mode at the same time as a room-air-dependent
heat-producing appliance is being operated.
It is only possible to safely operate the appliance
▶
if the pressure in the room in which the heating
appliance is installed does not drop more than
4 Pa (0.04 mbar) below atmospheric pressure.
This can be achieved whenever the air needed for
combustion is able to enter through openings that
cannot be sealed, for example in doors, windows,
incoming/exhaust air wall boxes or by other tech-
nical means. An incoming/exhaust air wall box
alone does not ensure compliance with the limit.
In any case, consult your responsible chimney
▶
sweep. They are able to assess the house's entire
ventilation setup and will suggest the suitable
ventilation measures to you.
Unrestricted operation is possible if the appliance
▶
is operated exclusively in circulating-air mode.
WARNING ‒ Risk of fire!
Grease deposits in the grease filter may catch fire.
Never work with naked flames close to the appli-
▶
ance (e.g. flambéing).
Do not install the appliance near a heat-producing
▶
appliance for solid fuel (e.g. wood or coal) unless
a closed, non-removable cover is available. There
must be no flying sparks.
WARNING ‒ Risk of injury!
Changes to the electrical or mechanical assembly
are dangerous and may lead to malfunctions.
Do not make any changes to the electrical or
▶
mechanical assembly.
Parts that are accessible during installation may
have sharp edges and may lead to cutting injuries.
Wear protective gloves
▶
The appliance is heavy.
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
WARNING ‒ Risk of suffocation!
Children may put packaging material over their
heads or wrap themselves up in it and suffocate.
Keep packaging material away from children.
▶
Do not let children play with packaging material.
▶
WARNING ‒ Risk of poisoning!
Risk of poisoning from flue gases being drawn back
in.
Do not emit the exhaust air into a smoke or ex-
▶
haust gas flue that is in operation.
Do not emit the exhaust air into a shaft that is
▶
used to ventilate installation rooms for heat-produ-
cing appliances.
If the exhaust air is to be conveyed into a smoke
▶
or exhaust gas flue, you must obtain the consent
of the heating engineer responsible.
Risk of poisoning from flue gases being drawn back
in.
If an extractor hood with an open-flued heat pro-
▶
duction source is installed, the power supply for
the extractor hood must be provided with a suit-
able safety switch.
Information about the electrical
connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
WARNING ‒ Risk of electric shock!
It must always be possible to disconnect the appli-
ance from the electricity supply. The appliance must
only be connected to a mains socket that has been
installed correctly.
An all-pole isolating switch must be integrated into
▶
the permanent electrical installation in accordance
with the conditions of overvoltage category III and
in accordance with the installation regulations.
The permanent electrical installation must only be
▶
wired by a professional electrician. We recom-
mend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
Do not kink or trap the connection cable, and
¡
keep it away from sharp edges.
Route the connection cable in such a way that it
¡
does not touch the hot casing.
Use only the connection cable that is supplied
¡
with the appliance or is provided by technical
after-sales service.
This appliance complies with the EC interference
¡
suppression regulations.
The appliance corresponds to protection class 1.
¡
You should therefore only use the appliance with
a protective earth connection.
The manufacturer shall assume no liability for mal-
¡
functions or damage resulting from incorrect elec-
trical wiring.
Preparing the electrical connection
Requirement: Only after-sales service staff who have
been trained accordingly may carry out work on the
inside of the appliance or replace the power cord.
Observe the information about the electrical con-
1.
nection.
An incorrect installation, an improper installation
or connection invalidates the warranty.
If a longer mains power cable is required, contact
2.
the after-sales service. Connecting cables up to
2.20 m are available.
On appliances without a preinstalled cable, insert
3.
the power cable into the mains socket.
Opening the mains socket
Use a screwdriver to lift the cover of the mains
▶
outlet.
→ Fig.
15
Preparing the mains socket
Undo the screw.
1.
→ Fig.
16
Use a screwdriver to lift the hose clamp.
2.
→ Fig.
17
Undo the hose clamp.
3.
→ Fig.
18
Connecting the cable to the mains socket
For 3 N, connect the cable to the mains socket in
1.
accordance with the following figure.
→ Fig.
19
17