Testing Your Fan; Important - Craftmade Pro Energy Saver 209 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test your fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain labeled FAN. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan
to MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF
setting. Test light with the pull chain labeled
LIGHT. (diagram 1) If fan and/or light do (does)
not function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
IMPORTANT: Reverse switch must be set either
completely DOWN or completely UP for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to ends of
the pull chains.
light
pull chain
extension
diagram 1
diagram 2
page 8
fan pull chain
extension
diagram 3 diagram 4
reverse
switch