Light Kit Assembly - Craftmade Pro Energy Saver 209 Guia De Instalacion

9. Light Kit Assembly (Optional).
Remove 3 screws from switch housing cap.
If you wish to use your fan WITHOUT the light kit,
align holes in switch housing cap with holes in
switch housing. (Note: The gap on the top edge of
the switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Secure switch housing cap with 3 screws that were
just removed. Please proceed to Section 10 to
complete installation without light kit.
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in switch
housing labeled LIGHT. Remove and discard plastic
that holds these 2 wires together.
Remove the hex nut and lock washer from
threaded rod in light kit fitter. Punch center cap out
of switch housing cap with a screwdriver. Feed
wires from light kit fitter through center hole in
switch housing cap. Screw switch housing cap
onto threaded rod on light kit fitter followed by
lock washer and hex nut. Tighten hex nut over lock
washer for a secure fit.
Connect BLACK (or BLUE) wire from switch
housing to BLACK wire from light kit fitter.
Connect WHITE wire from switch housing to RED
wire from light kit fitter. Be sure that molex
connections snap together securely.
Thread pull chain labeled FAN in switch housing
through corresponding hole labeled FAN in light
kit fitter. Thread pull chain labeled LIGHT in switch
housing through corresponding hole labeled
LIGHT in light kit fitter.
Carefully arrange wiring within the switch housing
cap. Align holes in switch housing cap with holes
in switch housing. (Note: The gap on the top edge
of the switch housing cap must align with the
reverse switch on the switch housing for the
proper fit.) Re-insert screws that were previously
removed and tighten all 3 screws securely with a
Phillips screwdriver.
To attach glass shade, align grooves on glass shade
with nodules on inside of light kit fitter and push
up gently on glass shade. Then, turn glass shade to
the RIGHT (clockwise) until it no longer turns.
NOTE: Pull down VERY GENTLY on glass shade to
make sure that glass shade is secure.
switch housing cap
hex nut
switch
housing cap
light kit fitter
reverse
switch
switch
housing
molex
connections
light kit fitter
*NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
page 7
motor housing
switch housing
switch housing cap
center cap
lock washer
threaded rod
black
white wire
wire
switch
black
red
housing cap
wire
wire
glass
shade
radio communications.
radio or