Entering Diagnostic Mode - Frigidaire FFTW1001PW0 Manual Del Usuario

ENGLISH

Entering Diagnostic Mode

1. Wake up unit.
Place cycle selector knob in 12:00 O'Clock
2.
position.
3. Position temp knob all the way to the left.
Press and hold START button for 10 seconds.
You will hear one short beep to indicate you
4.
completed Full Control Reset. Release START
button.
Place cycle selector knob in 11:00 O'Clock
position.
5.
Within 15 seconds, complete all of the follow-
ing instructions to enter Diagnostic Mode.
Turn temp knob all the way to the left.
1.
Press and release START button.
Turn temp knob all the way to the right.
2.
Press and release START button.
Turn temp knob all the way to the left.
Press and release START button.
3.
You will hear one long beep to indicate you
are in Diagnostic Mode.
NOTE
If left unattended in Diagnostic Mode for more than
5 minutes, the unit will automatically exit Diagnostic
Mode and return to normal functionality.
Press and hold CANCEL button for 5 sec-
onds.
1.
You will hear one short beep to indicate you
have exited Diagnostic mode.
Diagnostic Sub-Routine Selection
After entering Diagnostic Mode, select a Diagnostic Sub-Routine.
See Sub-Routine sections on next page.
12:00 o'clock
factory test mode
(not for use in field)
temp
alarm mode
Possible User Executions While in Diagnostic Mode
Press and hold CANCEL to exit Diagnostic Mode and
11:00 o'clock
return to normal operation. Chime will sound one short
beep as you exit Diagnostic Mode.
temp
Rotate cycle selector to desired Sub-Routine:
Alarm Mode or Test Mode.
Press START to enter selected Sub-Routine. See next
temp
page.
temp
2
factory test mode
(not for use in field)
test mode