Honeywell 850 Serie Manual Del Usuario página 3

ABOUT CERAMIC TECHNOLOGY
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
This type of heating technology provides fast, even heating.
The ThermaWave Ceramic Heater has an organic industrial design that maximizes heat output. It is
designed with fan power to improve convection in order to provide both all around or directional heating
comfort to you and your room.
ASSEMBLY
This heater requires simple, no tool assembly.
Unpack Main Body and Mounting Base (Fig. 1).
Place Mounting Base on a firm surface (upright in any direction). Place ThermaWave Main Body on
Mounting Base so Mounting Tabs are aligned with Base Slots. Press Main Body onto the Base until
Tabs snaps secure into the Slots (Fig. 2).
Fig. 1
SET-UP
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9 m) away
from any wall or combustible material.
DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE A TRIPPING HAZARD.
For best result, place heater on the floor to create warming room convection and allow heater to run
for 5-10 minutes to reach maximum heat output.
MOVING THE HEATER
Turn off the heater.
Allow it to cool for ten (10) minutes.
Unplug heater and move. This heater is equipped with a Cool Touch Handle for your convenience.
Fig. 2
3