Care And Maintenance; Troubleshooting; Corrective Action - Kobalt CSJ120KU Manual Del Usuario

OPERATINg INSTRUCTIONS
WORkINg HINTS FOR YOUR MULTI-PURPOSE SAW
• If your power tool becomes too hot, set the speed to maximum and run no-load for 2-3 minutes to cool
the motor. Avoid prolonged usage at very low speeds.
• ALWAYS use a blade suited to the material and material thickness to be cut.
• ALWAYS ensure the workpiece is firmly held or clamped to prevent movement.
• Any movement of the material may affect the quality of the cut. The blade cuts on the upward stroke
and may chip the uppermost surface.
• Ensure your uppermost surface is a nonvisible surface when your work is finished.

CARE AND MAINTENANCE

Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts
in your power tool. NEvER use water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. ALWAYS store your power tool in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.

TROUBLESHOOTINg

PROBLEM
The tool suddenly stops
during operation.
POSSIBLE CAUSE
1. Overload
2. Battery temperature too high
3. Low battery capacity

CORRECTIvE ACTION

1. Relieve the load on the machine
immediately and allow cooling for
approximately 30 seconds at the
highest no-load speed.
2. Allow the battery pack to cool.
3. Charge the battery pack.
13
kobalttools.com