Publicidad
Idiomas disponibles
Idiomas disponibles
Visor replacement (face shield)
First, the two screws (hexagonal socket) left and right helmet
side must be loosened.
The visor should then be removed from its anchorage.
A new visor is then inserted onto the seating bolts and the sup-
ports pushed into the plastic lugs in the reverse sequence. The-
se are then secured by the holding screws
Take care that the enclosed spring washers sit properly
and all screws are securely tightened.
Visor replacement (eye shield)
First, loosen the three main screws (hexagonal socket) on the
right, left and at the rear.
Then remove the shaft of the mechanism from the ratchet knob,
before taking the entire interior harness out of the helmet.
Subsequently, loosen the two holding screws (hexagonal so-
cket) of the eye shield anchorage and exchange the eye shield.
Then reinstall the entire interior harness in the reverse
sequence.
Take care that the enclosed spring washers sit properly
and all screws are securely tightened.
Replacement of the complete interior harness
Same procedure as above without removing the eye shield
Take care that the enclosed spring washers sit properly and all
screws are securely tightened.
Replacement of the ear covers
The ear covers are secured at three points (left, right and centre
rear) to the
head band and addionally fixed to the helmet shell by hook and
loop. To replace the ear covers, take out the nipples on both si-
des and on the back from the head band fixings. This works
best, if the attachment arm is pressed lightly away from the hel-
met shell. Then loosen both screws on left and right side of the
helmet shell. Remove ear covers from hook and loop fixing and
replace it.
Remount ear covers in the reverse sequence.
Colours
HEROS-XT white
HEROS-XT high vis. yellow
HEROS-XT yellow
HEROS-XT red
HEROS-XT black
Spare Parts
Face shield
Eye shield
Chin strap
Ear covers
ID NO 156880
ID NO 156881
ID NO 156882
ID NO 156883
ID NO 156884
ID NO 156890
ID NO 156891
ID NO 156892
ID NO 156893
Publicidad
