Hkoenig JOE48 Manual De Utilización página 5

OPERATING INSTRUCTIONS:
a) Ensure voltage used corresponds with the voltage indicated.
b) Turn the speed control to selected speeds: 0(off) and speedsⅠ, Ⅱ, Ⅲ is Slow, Middle, Fast.
c) Tilting angles-By pushing the tilt-guard, you can adjust the fan to any elevation preferred.
INSTALLATION
Step-1: screw out the 4pcs screws from the fan motor housing
Step-2: put the rear fan guard touch the fan motor housing, screws the screws back to lock
the rear fan guard
Step-3: insert the fan blade into the motor shaft,
Step-4: tight the screw to control the fan blade
Step-5: Put the front fan guard on the rear fan guards, put back the clips to control the fan
guards well (at the bottom of the fan guard, there is a safety screws, install it into the rear
fan guard hole and tight it)
Step-6: Contact with the electrical for using
SECURITY GUIDE
u Never touch the blades with hand or any object!
u Do not pull the cord too hard. If damaged after pro-long use, get it repaired by any
electrical repairman
u
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
u
Children should be supervised to ensure that they do not play with the appliance.
u
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.