Dimplex Revillusion RBF30 Manual Del Propietário página 19

Operation
Icon Function
Color
E
Themes
F
360
°
G
Brightness
H
Flame
Light
I
Sensor
J
Timer
Control Lock
Control Unlock
Description
Press multiple times to change the flame base colors
from Red to Blue to Off. (The first segment on the
display will change from "r" to "b" to blank) This
feature is active only when the flame effect is On.
Press multiple times to change the LEDs on the sides
and back of the unit from Midnight mode to white to
Light yellow to red. (The middle segment on the display
will change through 0 - 3 respectively. This feature is
active only when the Flame is ON.)
Press to change the LED lights from High to Low.
(The last segment on the display will change from "H"
to "L") The Realog
is ON and the flame effect is Off.
!
NOTE: When the Light Sensor is activated, High and
Low flickering brightness settings are also available
(Flashing "H" and "L").
Press to light the log set and start the flame effect.
Press again to turn feature Off.
Press to activate the ambient light sensor (ALS ON).
Press again to turn the sensor off (ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the
fireplace based on the ambient light in the room.
Press multiple times to change the sleeper timer in
0.5 hr increments from 0.5 hr to 8.0 hr before turning
off. The remaining time on the sleep timer displays.
Hold both Temp– (
touch panel controls for 2 seconds to disable the
manual controls.
Hold both Temp– (
touch panel controls for 2 seconds to enable the
manual controls.
LEDs remain On when the heater
®
) and Brightness (
) and Brightness (
) on the
) on the
19