LG OCF100 El Manual Del Propietario página 6

4
Fixing the Anchors and Screws
Please follow the instructions.
- Check the wall material and thickness of the finish.
- You can use the anchors and screws provided with the TV for walls made with concrete, lightweight concrete, soft fieldstone, hard
fieldstone, brick, or cellular blocks.
- Do not mount the device on walls made with plaster board or medium-density fiberboard (MDF). In this case, the anchor and screws must
be inserted into the concrete behind the finish. If there is no concrete on the other side, then you must install a separate hanger first to fix
the anchors and screws to.
- When installing it on a wall not specified in this manual, make sure each mounting position can withstand an load of 70 kgf (686 N) and a
shearing load of 100 kgf (980 N) or more.
a
d
- Use Ф 8 mm drill bit for concrete and a hammer (impact) drill.
a. Drill a hole with a depth of 80-100 mm, where the anchor will be attached to, using an 8 mm drill bit.
b. Clean out the drilled hole.
c. Insert the provided anchor into the hole. (Use a hammer when inserting the anchor.)
d. Place the wall mounting bracket close to the wall. Place the angle adjusting attachment facing upward.
e. Insert the wall mounting screw into the hole and tighten it.
Tighten the screw using a recommended torque of 45 kgf/cm - 60 kgf/cm or more.
5
Installing the Wall Mounting Supporter
Attach the screws
Wall mounting screw, 4 EA
6
b
Wall Mounting Screw
e
Anchor
c
→ Tighten the 4 wall mounting screws.
→ If either of the mounting locations is inappropriate for
installation, move both of the brackets to the locations
that meet the conditions above.
→ Fix the wall mounting supporter using the wall mounting
screws as shown in the illustration.
→ Tighten the screws until the wall, the wall mounting
supporter, and the screws are joined together securely
using a Phillips screwdriver (manual or drill) or 8 mm
spanner.