Publicidad
en
Safety notes
CAUTION
Failure to observe the safety notes
Potential injury to persons and damage to property
● Observe the following safety notes.
Installation may only be performed by an
instructed specialist.
The product described may only be used for its
intended use.
If you require tools such as a ladder, these must
be safe and must be intended for the work in
hand.
Intended use
The 19" mounting kit is a retainer for installing a
station into a 19" rack or into a 19" cabinet.
Installation instructions
To fix a station, the two retainers enclosed with the kit
must be mounted.
These installation instructions apply to all housing
variants.
Caption
Fig. 1, Installation position
1
Station or rear panel of housing
H
Distance between the top and bottom
mounting holes in the rear panel
D
Depth of the rear panel, as of a mounting
frame of 19"
Fig. 2, Assembling the 19" mounting kit
1
Threaded holes
2
Mounting slots
3
4x screws
4
Crossbar, left
5
Housing clamp
6
Crossbar, right
Building Technologies
Fire Safety & Security Products
Fig. 3, Installation and housing mounting
1
Top 19" retainer
2
Bottom 19" retainer
3
Threaded holes
4
Fixing screws in the rear panel
5
Rear panel of housing
6
4x fixing screw
4x washer
7
Mounting holes in 19" frame
8
19" frame or 19" housing
Installation
Screw the crossbars, Fig. 2 (4), (6), together with
1.
the housing clamp, Fig. 2 (5). Note the installation
depth (D) of the rear panel.
Position the top 19" retainer, Fig. 3 (1), at the
2.
required display height of the station.
3.
Secure the top 19" retainer, Fig. 3 (1), to the 19"
rack or in the 19" cabinet, Fig. 3 (8), by inserting the
two screws and washers, Fig. 3 (6), through the
mounting holes, Fig. 3 (7), of the frame.
4.
Position the bottom 19" retainer, Fig. 3 (3),
according to the distance of the mounting holes (H)
for the corresponding rear panel, Fig. 1 (1).
Secure the bottom 19" retainer, Fig. 3 (2), according
5.
to step 3.
Secure the station, Fig. 3 (5) to the top mounting
6.
holes by inserting the screws, Fig. 3 (4) through the
rear panel on the top retainer, Fig. 3 (1).
Adjust the exact position of the installation depth by
7.
loosening the screws, Fig. 2 (3), and moving them
in the slots, Fig. 2 (2).
8.
Then tighten all the screws.
Additional documentation
Information about further installation steps can be
found in the document Installation 008851.
3
A6V10332588_a_--_--
04.2011
Publicidad
