Rear Panel-Px-850A Internal Drive - Plextor PX-850 Manual De Instalación Y Usuario

Section 2. Installing the PX-850A Internal PATA Drive
Rear Panel—PX-850A Internal Drive
Also familiarize yourself with the drive's rear panel.
Figure 2: Rear panel of the PX-850A internal PATA drive
• Mode jumper: Use the mode jumper to select operation as an IDE
master or slave, or for cable select. In general, leave this jumper at
its factory setting, which is master; and ensure that any other device
on the bus is jumpered as slave.
• IDE cable connector: Connects to your computer's IDE (PATA)
interface using 80-conductor Ultra cable.
NOTE: Although the PX-850A will operate with a 40-wire IDE cable, it
may not be able to write at 22X unless an 80-conductor IDE/ATA
cable is used.
• Power connector: Connects to your computer's power supply to
provide DC +5 volts and +12 volts to the PX-850A.
10
PX-850 Installation and Users Manual