Troubleshooting - Pelonis FS45-9L El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GFCI OPERATION
The GFCI in the power supply cord of this fan has 2 buttons "TEST" and "RESET". If you wish to see if the GFCI
circuit is functioning properly press the "TEST" button. The fan will immediately shut off as if the GFCI has been
activated and the window between the button will change to black. This lets you know the GFCI circuit has been
activated. Press the "RESET" button and the fan can be turned on again and the window between the buttons
will show orange. This indicates the GFCI circuit has not been activated and the fan should operate normally.
MAINTENANCE INSTRUCTION
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service personnel if
service is needed.
1. Before cleaning and assembling, do not plug the pins into the socket.
2. To ensure adequate air circulation to the motor. Keep vents at the rear of the motor housing from dust, fluff
and etc. A vacuum cleaner can not be used to clean these vents before unplug. Do not disassemble the
fan remove fluff.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
Do not use any abrasive detergent or solvents to avoid scratching the sufrace.
Do not use of the following as a cleaner: gasoline, thinner, bending.
4. Do not allow water or any other liquid into the motor housing or interior parts.
Misting Nozzle Maintenance:
1. To clean the misting nozzles, use a pair of needles nose pliers to twist each nozzle counterclockwise.
2. Once removed, soak the nozzles in white vinegar for 2 hours.
3. Rinse each nozzle with water and place back into the front fan grill.
4. Twist clockwise until secure. DO NOT over tighten.

TROUBLESHOOTING

1. Problem
Misting features sputters or does not mist at all.
Solution
● Ensure your outside water faucet is turned all the way on.
● Check the fan's valve lever and make sure it set open.
● Check water hose for kinks or buckles.
● The valves on the fan may be clogged. Follow the instructions in the "Misting nozzles Maintenance" section
above.
2. Problem
Fan will not run.
Solution
● Ensure the fan is plugged in.
● Check the GFCI on the fan's plug. If the window is black the GFCI has been tripped and needs to be reset.
● Press the "RESET" button on the plug. If the GFCI window is orange then the circuit is active and does not
need to be reset.
3. Problem
Fan will not oscillate.
Solution
● Ensure the oscillation knob on the fan is pressed in.
4. Problem
GFCI continues to activate.
Solution
● Try using a different power outlet.
CLEANING
1. Be sure to unplug the power cord from the outlet before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge. Thoroughly remove soap film with
clean water.
3. Be sure not to get water or other liquid enter the inside of the motor.
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

758415

Tabla de contenido