Emptying The Dust Drum; Blowing Feature - Craftsman 113.177135 Manual Del Usuario

SP6523-3.qxd 11/13/06
Emptying the Drum
WARNING: To reduce the risk of
injury from accidental
unplug power cord before emptying
the drum.

Blowing Feature

Your vac contains a blowing feature. It has
the capability to blow sawdust and other
debris. It is excellent to use to blow dust
and debris out of garages or off patios and
driveways. Follow the steps below to use
your vac as a blower.
1. Locate blowing port of your vac.
2. Insert one end of the 4 foot x 1-1/4 inch
hose into the blowing port.
4. Turn vac "ON" and you are ready to use
your vac as a blower.
NOTE: If you need additional length at the
end of the hose, extension wands are
available at Sears retail stores as stock
no. 9-17861.
8:15 PM Page 9
1. Remove the power head assembly of
the wet/dry vac by pulling outward on
starting,
the latches located on each side of the
vac. Lift off the power head assembly.
2. Dump the drum contents into the proper
waste disposal container.
WARNING:
eyewear complying with ANSI Z87.1
(or in Canada CSA Z94.3) when using
as a blower.
WARNING:
bystanders, keep them clear of
blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/blower for
extended hours or when using it in a
noisy area.
9
Always wear safety
To avoid injury to