Operating Instructions For The Router Table; 28. Switch Box Operation - Kobalt K7343 Manual Del Usuario

OPERATING INSTRUCTIONS FOR THE ROUTER TABLE

When using the router installed in the table, use the
following instructions.

28. SWITCH BOX OPERATION

Two receptacles are located at the back of the integrated
safety switch (V). Use one for plugging in the router. The
other may be used to plug in a vacuum or a light (not
included). Two dust shields are designed to protect the
receptacles.
WARNING: To ensure safety and reliability, when one
receptacle is used for the router, the capacity of the other
receptacle is limited to 4 A. The total current drawn by the
two devices must not exceed 15 A.
a. Insert the safety key
into the integrated safety switch (V).
b. To turn the switch ON,
pull the integrated safety switch up.
c. To turn the switch OFF,
push the integrated safety switch down.
WARNING: Never leave the router unattended while
it is running or before it comes to a complete stop.
d. To lock the integrated safety switch in the OFF
position, push the integrated safety switch down to
turn the tool OFF, then remove the safety key from the
switch.
Using a vacuum
The vacuum adaptor in the fence assembly is
2-1/2 in. diameter. Select the vacuum accordingly.
NOTICE: Operating the router table without a vacuum
can result in an excessive build-up of sawdust and wood
chips under the fence assembly and guard and in the
cabinet, reducing the performance of the router table and
fence assembly.
28a
28b
28c
28d
27
DUST SHIELD
SAFETY KEY
V
kobalttools.com