Routine Care - BOND MANUFACTURING BH7001-1 Manual Del Usuario

USING A LONG MATCH OR LIGHTER
1. Connect propane (LP) cylinder (See above pages).
2. Before lighting, move the lava rocks with a small shovel to allow access to the pilot
located inside the screen.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are
completely cooled.
3. Locate the burner control knob and make sure it is in the "OFF" position.
4. Wearing heat resistant gloves position a lit long match or lit long neck lighter close to
the pilot. DO NOT lean over the burner while lighting.
5. Push and turn burner control knob to the "PILOT" position. The
pilot should light immediately.
6. If the pilot does not light immediately, turn the burner control knob
to "OFF", wait 5 minutes for gas to clear and repeat the lighting
procedure. If pilot still will not light, refer to the Troubleshooting Section.
7. Flame height can be changed by adjusting the burner control knob between the
"LOW" and "HIGH" positions.
8. Always check burner flames periodically to ensure proper operation. Flames should
be mostly yellow with some blue for best performance.
TO EXTINGUISH
1. Push and turn burner control knob clockwise to the "PILOT" position. (Normally,
burner will make a slight popping sound when extinguished). Main burner will
extinguish but Pilot flame will remain ON.
2. To extinguish Pilot flame, depress Control Knob and continue to turn it clockwise to
OFF.
3. Close the LP tank valve.
4. Disconnect the regulator from the LP tank to close the gas supply when not in use.
5. Make sure that the unit is completely cooled before touching any of the components
or putting on the cover.

ROUTINE CARE

 Keep your appliance free and clear from combustible materials.
 Visually inspect burner for obstructions, keep tank enclosure free and clear from
debris.
 After the burner and lava rocks are completely cooled down, use a soft brush to get
rid of the mild stains, loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
 Stubborn stains, discoloration and possibly rust pitting can occur from exposure to
harsh outdoor conditions.
 Be careful not let any powder or solvent come in contact with painted or plastic
components as damage may occur.
MAINTENANCE
 Store the appliance in a cool dry place away from direct sunlight.
 Make sure both the gas and the appliance are turned off before changing battery.
Please refer to the process of inserting battery.
 Protect your appliance with the cover when not in use.
 The propane cylinder must be disconnected and stored outdoors before the
appliance can be stored indoors.
 Use Manufacturer approved or supplied replacement parts and accessories only.
Otherwise may void the warranty of this product and result in a hazardous condition.
 Please contact the Manufacturer for information regarding replacement hoses,
11