Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
HDCC-01
Honda backup camera retention
2012-up
• Provides accessory power (12-volt 10-amp)
• Used in amplified and non-amplified systems
• Provides NAV outputs (parking brake, reverse, and V.S.S.)
• ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• Retains balance and fade
• Retains ability to change the factory clock
• Retains factory 3.5 AUX jack
• Micro "B" USB updatable
InteRFaCe COmPOnents
• HDCC-01 interface • HDCC-01 harness
• 8-pin subwoofer harness
• 16-pin harness with stripped leads
aPPLICatIOns
HOnDa
Civic
2012-2013
METRA. The World's best kits.™
Installation Instructions for HDCC-01
FeatuRes
CR-V
2012-2014
CR-V (without
LaneWatch camera)
1-800-221-0932
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the (2) Red wires to the accessory wire.
• Connect the Orange/White wire to the illumination wire. If the aftermarket radio does
not have an illumination wire, tape it off and disregard it.
• Tape off and disregard the Gray, Gray/Black, Green, Green/Black, and Brown
wires, they will not be used in this application.
The following wires are for the aftermarket radios that have navigation built in:
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
From the HDCC-01 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
2015-up
• Connect the Yellow wire to the battery wire.
• Connect the Blue/White wire to amp turn-on wire.
• Connect the White/Red RCA to the audio AUX in of the aftermarket radio (if equipped).
metraonline.com
tOOLs RequIReD
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
Connections to be made
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
(continued on next page)
Publicidad
Manuales relacionados para Metra HDCC-01
Resumen de contenidos para Metra HDCC-01
- Página 1 Honda backup camera retention • Connectors (i.e. butt-connectors, bell caps, etc.) 2012-up Caution: Metra recommends disconnecting the negative battery terminal before FeatuRes beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition.
- Página 2 For the following (8) wires, if the vehicle does not have a factory amplifier, cut Initializing the HDCC-01 off the RCA jacks to expose the speaker wires and use those instead. attention: If the HDCC-01 loses power for any reason, the following step will • Connect the White wire to the left front positive speaker output. need to be performed again.
- Página 3 Honda retención de cámara de seguridad (ejemplo: conectores de extremo, de campana, etc.) 2012 y mas PRECAUCIÓN: Metra recomienda desconectar el terminal negativo de la batería antes de comenzar cualquier instalación. Todos los accesorios, interruptores y, especialmente, CaraCterístiCas las luces indicadoras de airbag deben estar enchufados antes de volver a conectar la • Provee corriente de accesorios (12 voltios 10 amperes)
- Página 4 • Conecte el arnés de 16 pins con conectores pelados a la interfase. determinados sistemas de seguridad también podría provocar daños a las personas. si tiene alguna • Conecte el arnés HDCC-01 a la interfase y luego al vehículo. pregunta al respecto, llame a la línea de ayuda o a metra, al 1-800-221-0932 para obtener asistencia. • Cuando todas las conexiones estén hechas, vuelva a conectar la terminal EL CONOCIMIENTO ES PODER negativa de la batería.