Metra HDCC-01 Instrucciones De Instalación página 2

For the following (8) wires, if the vehicle does not have a factory amplifier, cut
off the RCA jacks to expose the speaker wires and use those instead.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
From the 8-pin subwoofer harness to the aftermarket radio
(amplified models only):
• Connect the White RCA to the subwoofer output.
12-pin pre-wired asWC-1 harness:
This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disre-
gard this harness. If it will be used, please refer to the ASWC-1 instructions
for radio connections and programming.
note: Disregard the harness that comes with the ASWC-1.
Installing the HDCC-01
With the key in the off position:
• Connect the 16-pin harness with stripped leads into the interface.
• Connect the HDCC-01 harness into the interface, and then into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
note: If using the ASWC-1, connect it after you initialize and test
the HDCC-01, with the key in the off position.
METRA. The World's best kits.
HDCC-01
attention: If the HDCC-01 loses power for any reason, the following step will
need to be performed again.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
setting the factory clock:
• Press and hold the SOURCE button on the steering wheel for 15 seconds to get
• Press SEEK-UP or SEEK-DOWN to select hours, minutes, etc. Press VOLUME-UP
• Either press SOURCE again, or wait 5 seconds with no activity to exit the clock
ImPORtant WaRnInG
This product includes instructions for installation which must be carefully followed. The instructions
are worded in such a manner to assume that the installer is capable of completing these type of
electronic installations. If you are unclear as to what you are instructed to do or believe that you do
not understand the instructions so as to properly and safely complete the installation you should
consult a technician who does have this knowledge and understanding.
Failure to follow these instructions carefully and to install the interface as described could
cause harm to the vehicle or to safety systems on the vehicle. Interference with certain
safety systems could cause harm to persons as well. If you have any questions in this regard
please call the Help line or metra at 1-800-221-0932 for assistance.
1-800-221-0932
™
Initializing the HDCC-01
ignition back off, then back on again.
extra features
into the clock setting mode.
or VOLUME-DOWN to set the values.
setting mode.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
metraonline.com
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians