Diagnostic Software Access Dsa; Start Screen For Fsa System Software; Fsa System Software Language Configuration; Fsa System Software Screen Layout - Bosch FSA 740 Manual Original

!
Measurements on the CRI Piezo are only permitted
with special adapter cables (optional accessories).
!
The measuring probes included in the test prod set
(1 687 010 153) can only be used for measurements
below 30 volt.
General procedure for measurements on the vehicle:
1. Switch off the ignition.
2. Connect the FSA 740 with battery (B–) or motor
mass via connecting cable B–.
3. Connect required measuring lines to the vehicle.
!
Do not hold the measuring lines with your hand dur‑
ing measurement.
4. Switch on ignition.
5. Perform measurement.
6. Switch off the ignition after measuring.
7. Disconnect measuring lines on the vehicle.
8. Disconnect connecting cable B–.
"
Measurement complete.
5.3

Diagnostic Software Access DSA

With DSA, you can:
R
Start Bosch applications (automatically as well).
R
Make interface settings.
R
Select DSA and Bosch application language.
R
Install software.
R
Update customer and vehicle data.
R
Terminate Bosch applications.
You will find more information in the DSA online help.
Robert Bosch GmbH
Operation | FSA 740 | 23
5.4

Start screen for FSA system software

Fig. 4: Start screen after device is switched on
i
If several applications are open, the speed of the
FSA system software may be impaired.
5.5 FSA system software language con-
figuration
In the "Settings" menu, you can also select the lan‑
guage with which you want to work in FSA 740. This
language will then be used for the other Bosch applica‑
tions as well.
5.6

FSA system software screen layout

Fig. 5: Functional screen layout
1 Program toolbar is displayed in all program levels: e.g. program
name, test step
2 Information box with information and instructions for operator
3 Status bar with information on the vehicle and sensors
4 Window area for test results
5 Hardkeys and softkeys
en
1 689 979 895 | 2014-10-28