Bosch 1 687 246 029 Manual Original página 7

4. Operation
4.1 Assigning a channel to the BEA 750
receiver
To operate several BEA 750 units with the remote con-
trol, individual channels must be assigned to the recei-
vers of the BEA 750 units.
i
A maximum of 4 BEA 750 units can be operated
using the channels 1, 2, 5 and 6.
Example – assigning BEA 750 to channel 2:
1. Use the on/off switches on the backs of the units to
switch off all BEA 750 units present at the workshop
(see 1 689 989 339).
i
The BEA 750 receiver can only be assigned a channel
within one minute of switching it on.
2. Use the on/off switch on the back of the BEA 750
whose receiver is to be assigned to channel 2.
3. Carry out the following steps within one minute of
switching it on.
4. Point the remote control at the BEA 750 receiver
(see 1 689 989 339).
5. Press and hold <CH> (fig. 1, item 12) and the <F4>
function key (fig. 1, item 5) simultaneously for 4
seconds.
6. Press and hold <CH> (fig. 1, item 12) and the <F2>
function key of the <G2> range (fig. 1, item 3) simul-
taneously for 4 seconds.
? The BEA 750 receiver is now assigned to chan-
nel 2.
? BEA 750 can now be controlled and operated via
channel 2.
i
The <F5> and <F6> function keys can be used to
assign channels 5 and 6 to BEA 750 receivers in the
same manner.
i
The channel assignment of a BEA 750 receiver can
be changed at any time.
Automotive Service Solutions
Operation | 1 687 246 029 | 7
4.2 Setting a channel on the remote con-
trol
To use the remote control to operate several BEA 750
units on different channels, the remote control must be
set to the correct channel.
Example – setting the remote control to channel 5:
¶
Press and hold <CH> (fig. 1, item 12) and the <F5>
function key of the <G1> range (fig. 1, item 2) simul-
taneously for 4 seconds.
? The remote control is set to channel 5.
? The remote control can now be used
to operate the BEA 750 whose receiver
is assigned to channel 5.
i
The <F1>, <F2> and <F6> function keys are used to
set the remote control to channels 1, 2 and 6 in the
same manner.
i
The channel setting of the remote control can be
changed at any time.
4.3 Displaying the channel assignment of
a receiver on BEA 750
i
The display of the channel assignment of a BEA 750
receiver is not dependent on the channel set on the
remote control.
1. Make sure the keyboard is correctly connected to
the BEA 750.
2. Point the remote control at the BEA 750 receiver
(see 1 689 989 339).
3. Press and hold the <CH> key for 8 seconds.
? The NUM LED on the keyboard connected to the
BEA 750 will flash to indicate the channel set (e.g.
twice for channel 2).
en
|
1 689 989 338 2017-05-10