HORIZON 24994 Instrucciones De Instalación página 7

8. Install hitch – Using hammer, flatten hook tabs behind bumper plates. Align bumper beam with hitch on the floor. Raise the hitch and bumper beam into position
aligning holes on the end panel. Loosely install (6) M8 bolts ①, (6) 5/16'' lock and flat washers ②③ to the bumper beam and hitch, see Figure 1.
a.)
9. Tighten all M8x1.25x40 CL8.8 fasteners with torque wrench to 20 ft -lb (27 N*m).
10. Trim lower fascia –Using a tape measure, marker, and utility knife, measure, mark, and trim the lower fascia as shown in Figure 3.
©2020 Horizon Global Americas Inc. - Printed in Mexico
b.)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
����
����
Rearward
����
"
C L
of Vehicle
Bottom view of lower fascia
Figure 3
���� "
Sheet 7 of 24 24994NP 03-23-20 Rev. A