Technical Specifications - Cebora 436.00 Manual De Instrucciones

4 APPLICATION
Kit item no 436.00 must be installed in power sources WIN TIG 394.XX, 395.XX, 396.XX, 380.XX and
381.XX and in WF5 robot wire feeder, item no 1648, for KINGSTAR MIG.
The function of the kit is to regulate the welding gas flow rate during the TIG or MIG process.
It is used to monitor gas consumption in order to optimise consumption levels and weld quality.
Gas consumption is reduced by eliminating the initial dispersal that arises when the ON - OFF solenoids
open (Fig. 2.1).
Using the kit gives a delivery gas flow profile of the type shown in Fig. 2.2.
EN
Gas delivery is achieved via controlled opening by the solenoid and flow sensor unit (3) and the presence
of an appropriately calibrated (3 bars) pressure regulator (2).
In TIG applications, the kit is currently calibrated for Argon only; in order to use the regulator with other
types of gas, specific correction coefficients must be adopted and multiplied by the set-point value (see
chapter 7).
In MIG applications, the power source already holds information on gas types because the curves are
synergic.
Once connected, the kit is automatically recognised and the user only needs to adjust the set-point to the
flow.
4.1

Technical specifications

Flow rate
Inlet pressure
Power supply
Gas Type
Fieldbus
Working Temperature
5 INSTALLATION
The following instructions refer to Fig.3-4 and the wiring diagrams at the end of this manual (Chapter 8).
For further information, consult the power source Instruction Manual.
The installation operations described below must be carried out only by qualified personnel. All
electrical connections must be made in full compliance with current accident protection legislation.
3300121
Fig. 2.1
Min.
l/min 5
bar 0,5
V //
Ar, CO2,
ArXXCO2XX,
ArXXHeXX
CANOpen
°C -20
Typ Max.
// 30
// 8
24 //
// 40
WARNING
Fig. 2.2
12