Steren NB-1010 Manual De Instrucciones página 15

4. INSTRUCTIONS
1. Plug your equipment into the UPS contacts. Make sure not to overload the
capacity of the equipment.
2. Insert the power cord into an electrical outlet.
3. Press the on/off button.
4. Turn on the equipment connected to the ups.
5. The 'Normal' message should light up on the display.
6. If a failure occurs while the computer is running, it will light in the display the
message "Battery" and an alarm will sound. You will have up to 60 minutes of
backup. When power is restored, the alarm will stop sounding.
7. When the battery is about to be discharged, the message "Unusual" will
illuminate.
During battery mode, when the voltage falls below the 21 V, the "Unusual"
message turns until the computer shuts off automatically.
If a short circuit or an overload occurs during the "Battery" mode, "Unusual"
will appear on the display and an alarm will sound for 30 seconds.
After this time, the device will switch off automatically. You must unplug it
6 6
and connect it again to have it working properly again.