Cleaning And Care; Troubleshooting - HoMedics HUM-SS10 Manual De Instrucciones

10
PROBLEM POSSIBLE CAUSE
Power Light is off • Unit is not plugged in
• No power at unit
SoundSpa will not • Unit is not plugged in
turn on • Volume is down too low
• No sound selection has
been made
• Sleep Mode cycle is over
Peculiar Odor • If new unit
• If unit is in use, the odor
may be a dirty tank or old
tank water
Excessive Noise • Unit is not level
• Low water level
White Dust Accumulation • Hard water used
• Demineralization Cartridge
needs replacement
SOLUTION
• Plug unit in
• Press the POWER button
to turn the power on
• Check circuits, fuses, try a
different outlet
• Plug unit in
• Turn the SOUNDSPA
POWER/VOLUME knob
clockwise to increase
volume
• Press a sound selection
button to choose a sound
• Use the SOUNDSPA
POWER/VOLUME knob to
turn the SoundSpa OFF,
then back ON again.
• Open the water tank cap
and keep it in a shady and
cool place for 12 hours
• Empty the old water,
clean the tank and fill
with clean water
• Place unit on a flat,
even surface
• Check the water level. Refill
the tank if the water is low
• Use distilled water and a
Demineralization Cartridge
• Replace Demineralization
Cartridge
1 1