Displaying Information; List Of Viewable Messages; End Of Shift - Elettrobar OCEAN 360 Manual De Instrucciones

UK
•
Make sure the overflow has been removed.
•
Close the door and switch the dishwasher on.
•
Press the PROGRAMME SELECTION button (2) for the resin regeneration cycle; rEG will appear
on the display.
•
Press the START button (3) to start a cycle.
•
The regeneration cycle lasts around 20 minutes.
•
The dishwasher will switch off when the cycle has completed.
N.B. Do not switch off the machine if a regeneration cycle is underway
Door open
Rinse temperature
Wash temperature
Short wash
Medium wash
Long wash
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Page 8 of 12
INSTRUCTION MANUAL FOR DISHWASHERS
With the dishwasher on, press PROGRAMME SELECTION (2) for five
seconds, in sequence the following are shown:
•
"t" wash temperature
•
"b" rinse temperature
•
"CC" wash cycles carried out during the life of the dishwasher.

4.11 Displaying information

4.12 List of viewable messages

Number of cycles carried out
End of cycle
Automatic start enabled
Continuous wash
Final drain
Regeneration cycle or request

4.13 End of shift