Carton Contents; Tools Needed For Assembly - KNOVA KN DP-2000 Manual Del Usuario

Ocultar thumbs Ver también para KN DP-2000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRICAL REQUIREMENTS AND SAFETY
Fig. 2

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS
WARNING
If any part is missing or damaged, do not plug the drill press in until the missing or damaged
part is replaced, and assembly is complete.
Carefully unpack the drill press and all its parts, and compare against the list below.
To protect the drill press from moisture, a protective coating has been applied to the machined
surfaces. Remove this coating with a soft cloth moistened with a substance such as WD-40.

TOOLS NEEDED FOR ASSEMBLY

Grounding Lug
Adapter
CAUTION
This drill must be grounded while in use to
protect the operator from electric shock.
Make sure this is
connected to a
known ground.
Two-Pronged
Receptacle
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(When using 120 volts only)
Ampere Rating
More Than Not More Than
0
6
6
10
10
12
12
16
4
Total length of Cord
25ft. 50ft.
100ft.
150ft.
18
16
16
18
16
14
16
16
14
14
12
Not Recommended
WARNING
To avoid fire or
toxic reaction,
never use gas-
oline, naphtha,
acetone,
quer thinner or
similar highly
volatile
vents to clean
the drill press.
NOT SUPPLIED
• Adjustable wrench
• Hammer and
block of wood
• Combination
square
• Screwdrivers
14
12
12
lac-
sol-

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido