Installation - ISOFIX VOLTA 360 ST-3 Manual De Uso

4. PREPARATORY WORKS
3. Unhook the shoulder
pad straps from the
connecting piece
(fig.30).
4. Pull out both the
shoulder pads and the
two shoulder belts from
the slots (fig.31).
5. Open buckle (fig.32).
6. Roll the shoulder belts
together and store them
in the bag of fabric
cover (fig. 33).
7. Grasp the metal plate
from underneath and
turn it into a vertical
position. Push upwards
and slide the metal
plate through the slot
(fig.34).
8. Re-fitting the harness:
Simply follow the steps
in the opposite order.
Make sure the belt is not
twisted.

5. INSTALLATION

5.1 GROUP 0+
REARWARD FACING
(0-13 kg, from born to
approx.18 months)
WARNING
DO NOT place rear-facing
child seat on front seat
with active airbag, DEATH
OR SERIOUS INJURY can
occur.
adjust seat in most reclined position (see section 4.4).
2. Place seat in the direction facing opposite to the
1. Rotate seat to rearward
facing (see section 4.5),
Tip: Infant cushion is for child below 9 kg.
32
30
32
34
36 37
travel (fig.35, 36, 37).
5. INSTALLATION
5.1.1 Install use ISOFIX connectors and Top tether
31
(If your seat don't equipped ISOFIX or your car don't
equipped ISOFIX anchorage, please see section 5.1.2
Install use 3-point belt).
1. Install ISOFIX connectors (see section 4.6) (fig.
38).
2. Guide top tether along both sides,then attach
top tether hook to anchorage point. (see
section 4.7) (fig. 39).
3. Have your child sit down in the child seat. Adjust
33
headrest in proper height (see section 4.3),
adjust harness and lock buckle (see section 4.1),
and tighten harness. (see section 4.2) (fig. 40)
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK :
- the child safety seat is engaged on both sides with
the ISOFIX connectors in the ISOFIX.
- attachment points and that both buttons are
35
green.
- the child seat is firmly installed in the vehicle.
- the Top Tether is tightly tensioned over the
backrest of the car seat and the tension.
- Indicator is green.
- the straps of the child safety seat are close to the
body without constricting the child.
- the shoulder belts are correctly adjusted and the
straps are not twisted.
- the shoulder pads are at the same level as your
child's shoulders.
- the buckle latches are engaged in the harness buckle.
5.1.2 Install use 3-point belt
1. Open buckle then remove infant cushion (fig. 41).
2. Guide vehicle lap belt through both lower belt
guides, engage the buckle tongue in the vehicle
seat belt buckle. (fig. 42) Put infant cushion back.
CAUTION
The vehicle seat belt buckle must not be
positioned in the lower belt guide.
38
CLICK
39
40
41
42
33