ISOFIX VOLTA 360 ST-3 Manual De Uso página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. INSTALLATION
7. Have your child sit down in the child seat. Adjust
headrest in proper height (see section 4.3),
adjust harness and lock buckle (see section 4.1),
and tighten harness. (see section 4.2) (fig. 54)
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK :
-
the child safety seat is engaged on both sides with
the ISOFIX connectors in the ISOFIX attachment
points and that both buttons are green.
- the child seat is firmly installed in the vehicle.
- the straps of the child safety seat are close to the
body without constricting the child.
- the shoulder belts are correctly adjusted and the
straps are not twisted.
- the shoulder pads are at the same level as your
child's shoulders.
- the buckle latches are engaged in the harness
buckle.
WARNING!
For Group 1 installation, this seat also
can use vehicle belt only, it has been tested and
homologated also. If you wantonly use vehicle belt
installation, just skip the ISOFIX connector relative
content.
5.3 GROUP 2 AND 3 FORWARD FACING
36kg, approx. from 3 years to 12 years)
1. Remove the harness when use as group 2/3 (see
section 4.8).
2. Rotate seat to forward facing (see section 4.5).
Place seat in thedirection facing to the travel.
(fig. 55, 56).
3. Install ISOFIX connectors, see section 4.6 (fig.57)
(If your seat don't equipped ISOFIX or your car
don't equipped ISOFIX anchorage, please install
only use 3-point belt).
4. Have your child sit down in the child seat. Adjust
headrest in proper height (see section 4.3). Pull
out the vehicle seat belt and guide it in front of
your child to the vehicle seat buckle. Engage the
buckle tongue in the vehicle seat buckle (fig. 58).
36
54
55
56
(15-
57
5. INSTALLATION
CAUTION
The vehicle seat belt buckle must not be
positioned in the lower belt guide.
5. Place the diagonal seat belt section and lap belt
section on the side of the vehicle seat belt buckle
in the lower belt guide. (fig. 59).
6. Place the lap belt section on the other side of the
childseat in the lower belt guide.(fig. 60).
CAUTION
The lap belt section must lie as low as possible
over your child's hips on both sides
7. Guide the diagonal seat belt section into the belt
and is not twisted. (fig. 61)
FOR THE SAFETY OF YOUR CHILD, BEFORE
EVERY JOURNEY IN THE CAR CHECK :
- the child safety seat is engaged on both sides with
the ISOFIX connectors in the ISOFIX attachment
points and that both buttons are green.
- the child seat is firmly installed in the vehicle;
- the lap belt section runs through the lower belt
guides on both sides.
- the diagonal seat belt section on the side of the
vehicle seat belt buckle also runs through the
lower belt guide.
- the diagonal seat belt section runs through the
belt holder of the headrest.
- the buckle is engaged, belt is not twisted.
WARNING!
For Group 2 and 3 installation, this seat
also can use vehicle belt only, it has been tested and
homologated also. If you want only use vehicle belt
installation, just skip the ISOFIX connector relative
content.
58
59
60
61
37

Publicidad

Tabla de contenido
loading

Tabla de contenido