Master Audio
3.9. Flying
Only experienced people should fly speaker cabinets. Extreme care should be taken
to assure the load bearing capabilities of the structures where the cabinets will be
placed.
Hanging hardware (as chains, eyebolt, Lock Pins...) should be regularly inspected
and replaced if in doubt.
WARNING!!! DO NOT SUSPEND THE CABINETS FROM THE HANDLES!!!!
3.9.1. LN-26 / LN-8 Flying
The LN-26 and LN-8 incorporate a "U" bracket which allows the cabinet to be
mounted on a wall or ceiling. The bracket may be mounted with either nails or
screws, horizontally or vertically.
1
2
Fig.19. LN-26 / LN-8 bracket
Mounting:
1- Hold the bracket against the mounting surface, so you can mark the locations of
the mounting holes (1), and the wire hole (2).
2- Drill corresponding pilot holes on the wall and attach the bracket with screws (not
included).
3- Set the cabinet on the bracket and fix it through the two M6 (LN-8) / M8 (LN-26)
bracket knobs.
4- Adjust the cabinet for desired position and angle.
Additionally, the LN-26 / LN-8 incorporates 6 M8 rigging points to match with some
Standard accessories. These points are placed as follows:
*2 M8 points on the top side
*2 M8 points on the bottom side
*2 M8 points on the right side
LN Series. Versión 1.5
1
Nov 09
33