Wheel Assembly; Handle Assembly - Procom Heating 110 Manual Del Propietário

WHEEL ASSEMBLY

Models 160, 175 and 220
1. Slide Axle (A) through holes in wheel support frame.
2. Slide Wheel Spacer (B), then wheel (D) (concave side facing outward) onto axle.
3. Attach Acorn Nut (C) finger tight to end of axle.
4. Repeat steps 2 and 3 for opposite side, then tighten nuts with adjustable wrench.
Figure 2 - Wheel Assembly, 160, 175 and 220 models

HANDLE ASSEMBLY

Models 160, 175 and 220
1. Slide rear handle (E) onto Wheel Support Frame. Insert Screws (G) from rear and
attach lock nuts (F).
2. Place Front Handle (I) under flange of fuel tank and insert 4 screws (J)from top of
flange through holes in flange into holes in handle. Attach Lock Nuts (H) and tighten.
Screw, 10-24 x1.5 (G)
Lock Nut 10-24 (F)
Screw 1/4-20 x 1.75" (J)
Front Handle (I)
Figure 3 - Handle Assembly, 160, 175 and 220 models
4
ASSEMBLY
Axle (A)
Spacer (B)
Rear Handle (E)
www.usaprocom.com
Continued
Wheel (D)
Acorn Nut (C)
160108-01