Operation - Procom Heating 110 Manual Del Propietário

IMPORTANT: Review and un-
derstand the warnings in the
Safety section, pages 2 and 3.
They are needed to safely oper-
ate this heater. Follow all local
ordinances and codes when
using this heater.
TO START HEATER
1. Follow all ventilation and safety information.
2. Locate heater to provide maximum circu-
lation of the heated air. Follow all location
requirements noted in Safety, pages
2 and 3.
3. Fill fuel tank with fuel and attach fuel cap.
Use only kerosene, #1/#2 diesel/fuel oil,
JET A or JP-8 fuels to avoid risk of fire or
explosion. Never use gasoline, oil drained
from crank cases, naphtha, paint thinners,
alcohol or other flammable fuels.
4. Plug heater's power cord into approved,
grounded, three-wire extension cord. Exten-
sion cord must be at least six feet (1.8 m) long.
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 m) long, use 18
AWG (0.75 mm
• 11 to 100 feet (3.3 to 30.5 m) long, use
16 AWG (1.0 mm
• 101 to 200 feet (30.8 to 61 m) long, use
14 AWG (1.5 mm
5. Plug extension cord into standard 120
volt/60 hertz, 3-prong grounded outlet.
6. Push ON/STOP button to ON. Alarm will sound
and display will start countdown to ignition. 6
seconds after motor startup, LED will display.
7. Push MODE/RESET button to select
desired operating mode.
Please Note: When operating in Ther-
mostat Mode, press the MODE/RESET
button once to change to Manual Mode.
When operating in Manual Mode, Press
the MODE/RESET button twice within 5
seconds to change to Thermostat Mode.
Manual Mode LED On: Adjust output to
disired setting. Press
output. Press
Please Note: After startup, heater BTU
output can be immediately adjusted, but
adjustments will not take effect for 2 min-
utes. This allows the heater to stabilize.
160108-01

OPERATION

) rated cord
2
) rated cord
2
) rated cord
2
to raise the BTU
to lower the BTU output.
www.usaprocom.com
Thermostat Mode LED On: Adjust ther-
mostat by pressing
higher. Press
If thermostat set temperature is higher
than the surrounding air temperature,
heater should ignite immediately. If heater
thermostat set temperature is lower than
surrounding air temperature, heater will
not ignite.
WARNING: This heater is
equipped with a thermostat.
Heater may start at any time.
TO STOP HEATER
1. Push ON/STOP button to stop heater.
2. Unplug heater when not in use.
TO RESET HEATER
1. Wait two minutes before restarting.
2. Push MODE/RESET button to restart heater.
LED display will show surrounding temperature
unless up and down arrow keys are pressed.
After pressing these keys, display shows set
point temperature for five seconds and then will
change back to display surrounding temperature.
Exposure to direct sunlight or extreme cold may
affect temperature reading and/or thermostat
operation.
This thermostat will store the last set point
even if power is removed. Unit will maintain
this set point until a new set point is entered.
Figure 5 - Controls Display
Fault Codes
This heater will display fault codes whenever
there is a control shutdown. See Trouble-
shooting, pages 9 - 12, before attempting to
rectify any problems with your heater.
to change set point
to change set point lower.
7