Programming Of The Stop Button; Programming Of The Courtesy Light Code; Remove Transmitters From The Memory; Programming Working Times - GAPOSA QCzero Manual Del Usuario

QCzero QCzeroP
26 EN
3.4.3 PROGRAMMING OF THE STOP BUTTON OF THE TRANSMITTER
This procedure matches the chosen button of the transmitter to the STOP function, which immediately stops the motor's
movement and excludes the automatic closure.
OPERATIONS
Perform the procedure "PROGRAMMING OF THE SEQUENTIAL CONTROL" by holding the
STOP button while transmitting the radio signal. If the STOP button is not installed, it is
necessary to close the contact between the terminals 5 and 6 while sending the radio signal.
3.5 PROGRAMMING OF THE COURTESY LIGHT CODES
With this procedure it is possible to match a transmitter's button to the switching-on of a courtesy light.
In a normal activity the radio codes related to the courtesy light work in the following way:
- If Dip 5 is in ON position: at every radio signal the light's contact activates itself for 2 seconds
- If Dip 5 is in OFF position: at every radio signal the light's contact activates itself for 3 minutes.
It is possible to advance the switching off through a new radio signal while the light is switched on.
OPERATIONS
1. Place on the board the dip 7 in ON position (dip 9 and 10 must stay in OFF
position). It is possible to place in ON position the dip 5 as well only after
having place the dip 7 in ON.
2. Send the radio code to be memorized.
3. The TEST led makes 1 flash if code has been memorized, or it flashes 3 times if already memorized previously
(when memory is full and no more codes can be added the led flashes 5 times).
4. If further buttons or transmitters' memorization must be performed repeat step 2,
otherwise place the dip 5 and 7 in OFF position.

3.6 REMOVE TRANSMITTERS FROM THE MEMORY

It is possible to remove all transmitters from the memory by performing the control unit's reset, see page 24.

3.7 PROGRAMMING WORKING TIMES

ATTENTION TO THE MOTORS LINE! It is absolutely important to verify the motor's direction and the limit switch
position. If the motor's lines are inverted, the safety devices will have an inverted activity as well, creating in this way a
DANGEROUS situation!
Control unit with integrated receiver
ON ON
1 2 3 4 5 6 7 8 9 10
ON
ON
TEST
OFF
5
STOP
6
1 2 3 4 5 6 7 8 9 10
ON
50 cm
TEST
FLASH
1 2 3 4 5 6 7 8 9 10
OFF
IMPORTANT