Monogram ZWE23ESNSS Instrucciones De Instalación página 13

INSTALLING THE REFRIGERATOR
MEASURE CABINET
AT-1
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where refrigera-
tor will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
Width, W, should not be less than 36". The refrig-
erator will be placed approximately in the middle of
this opening.
Rear Wall
W
REFRIGERATOR
Front
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET
A
Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor up
against the rear wall, within W, and in line with the
desired location of the RH side of the refrigerator
(see Figure 1).
Figure 1 – Installation Overview
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
B Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
approximately 15 ¼" (38.73 cm) from the edge of
the sheet or the RH side of the refrigerator.
Hold down in position and use the anti-tip floor
C
bracket as a template for marking the holes based
upon your configuration and type of construction
as shown in Step 3. Mark the hole locations with a
pencil, nail or awl.
31-1000602 Rev. 0
Installation Instructions
(Cont.)
Baseboard
Thickness or
Countertop
Overhang
(Whichever Is
Larger) Plus
Any Desired
Clearance
RH Side
2 Wall Holes
Floor Bracket
to Install
RH Holes
15 ¼"
Rear RH
Corner of
Cabinet Wall
RH Side of
Locator
Refrigerator
Template Sheet
Anti-Tip Floor Bracket Installation
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET
C
Hold down in position and use the anti-tip floor
bracket as a template for marking the holes based
upon your configuration and type of construction
as shown in Step 3. Mark the hole locations with a
pencil, nail or awl.
NOTE:
• It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of the
anti-tip floor bracket). Both must be into either
the wall or the floor. Figure 2 indicates all the
acceptable mounting configurations for screws.
Identify the screw holes on the anti-tip floor
bracket for your configuration.
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET (cont.)
Figure 2 – Acceptable Screw Placement
Recommended Installation
– Wood
Minimum Acceptable #1 –
Wall Plate Stud
Minimum Acceptable #3
(If Required)
Locations
Recommended Installation
– Concrete
Minimum Acceptable #2
– Wood Floor
– Concrete Floor
13