Fein KBH25-2U Manual De Instrucciones página 22

en
22
When the power supply is disconnected while the motor
is running or when the switched-on power tool is
plugged in, the motor will not restart.
Insert the pilot bit with a turning motion into the tool
holder until it springs back.
Carry out core-drilling processes without interruption, if
possible. To complete a started and interrupted drilling
run, repeat the center-drilling process.
Do not use the power tool in a drill stand.
Replace dull pilot bits; they may not be reground.
Remove the chips and the drilled core after each drilling
process.
Chips are sharp and hot!
CAUTION
When changing a drill bit, pay attention not to damage
the cutting edges.
When core drilling layered material, remove the core and
the chippings after drilling each layer.
KBH25-2U (**): Apply core drilling only in gear setting 2.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available through
the FEIN customer service centre.
The current spares parts list for this power tool can be
found on our website at www.fein.com.
If required, you can change the following parts yourself:
Auxiliary handle, application tools
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
Instruction Manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-D1_IA,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.