Dmx Address Setting - TECshow UV BAR Manual De Usuario

DMX address setting

Set an address for each light, and accept the DMX
signal from DMX controller, as per the demand, user
can set the same address for all lights, or different
address for different light.
If set several light with the same DMX starting
address, all lights will accept the same DMX signal
from DMX controller and work synchronously.
If set different address for each light, the light will
5. RIGGING AND INSTALLATION
1
1. The light can work properly when the ambient
temperature is -25~40°C, do not use the light
when the ambient temperature is over 40°C or
under -25°C.
2. The installation has to be built and constructed
in a proper way that the rigging can hold 10
times of the light weight .
3. Don't stand under the light when installing, dis-
assembling, repairing or maintaining the light.
4. Please use safety chain to ensure good installation.
5. Fix the M8 screw of the hook clamp in ¢12.5mm
hole of the light handle.
P. 6
Tecshow UV Bar |
English version
accept signal from the DMX controller as per the
DMX starting address, if use this way, user must set
the DMX starting address for the light according to
channel quantity of each light.
This light has 2 DMX modes: 2/1 channels, when use
2-channel mode, the 1st light has starting address
1, the 2nd light has starting address 3 (1*2+1), the
3rd light has starting address 5 (2*2+1),...;
2
1. Hook clamp
2. Handle