Dmx Address Setting - TECshow SPINNER Manual De Usuario

Fixture dimensional drawing

DMX address setting

Each fixture must set a specific starting address. When re-
ceiving signal, fixture will receive channel control signals of
this address from the DMX controller.
For easy to use, the user can set the same address for several
fixtures , also can set up a unique address for every device.
If you set the same address for all fixtures, all the fixtures will
receive from the same DMX channels signal. All connecting
fixtures are jointly controlled, controller can't separately
control a device.
If you set a different address for each fixture, each fixture will
receive unique signal and can be controlled by DMX control-
ler separately.
Ringing
1) The applicable temperature for the lighting is between
-25°C to 40°C. Do not use the lighting under or above the tem-
perature.
2) The installation of the effect has to be built and construct-
ed in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.
3) The installation must always be secured with a second-
ary safety attachment, e.g. an appropriate safety rope.Never
stand directly below the device when mounting, removing or
servicing the fixture.
4) The operator has to make sure the safety relating and ma-
chine technical installations are approved by an expert be-
fore taking the device into operation for the first time.
5) These installations have to be approved by a skilled per-
son once a year.
6) M8 screws on the mounting bracket which for fixed be-
tween hanging bracket's ¢12.5mm hole.
SPINNER
ENGLISH VERSION
p. 7