Water Tank - pureguardian H1600 Instrucciones De Uso Y Cuidado

9.
Night Light Feature 10.
Water refill Button
Press the Night Lamp button at
When the Water Refill button lights
the top of the unit to illuminate
up it is time to refill the water tank.
the night light feature.
• Always unplug the unit before servicing it in any way.
• The temperature of the water remaining in the unit after use may be HIGH.
• Do not submerse the unit in water, or allow water to enter the inside of the unit or humidity
spout. Only put water into the water tank.
iNSiDE tHE BoDY oF tHE UNit
Pour excess water out of the unit, but do not allow it to enter the spout guide. Wash
out the unit with fresh water, using ONLY the cleaning brush and a soft cloth as needed.
oUtEr SUrFacE oF tHE UNit
Wipe the surface of the unit with a soft, damp cloth if needed.

WatEr taNK

If water spots remain in the water tank, wipe the inside with a soft cloth.
DO NOT use soap or detergents.
ULtraSoNic DiSK
Remove water tank (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). Diluted white vinegar will help to prevent this build up.
Fig. 1 Fig. 2
• Fully dry the inside and outside of the unit before storing it.
• DO NOT leave water in the unit.
• Store in a cool, dry place.
E-6
11.
Humidity Spout Direction
To change the direction of
the mist turn humidity spout
as desired.
*clean the disk with
the brush only. No
other cleaning tool
should be used.
Brush only. (Fig. 2)
ProBLEM SoLUtioN
Power Plug: Unplug and then try again.
Water mist and humidity
Power Failure: When the power is returned, try again.
are not produced.
Water Tank Installation: Make sure the water tank is
correctly attached. Make sure spring on tank
cap moves freely when pushed.
Excessive Water: Remove water tank. Empty a
small amount of water from the base of the unit.
Air blows but water mist
is not produced.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out
and try again.
The surface of the ultrasonic disk is dirty. Clean
with white vinegar.
Humidity level is low.
The water in the unit is too cold: Replace with cool,
but not cold water.
If ultrasonic disk is damaged contact
customer Service at 1.866.603.5900.
It may take 10-15 minutes before warm
humidity is created. The mist may not feel
Warm humidity is not produced.
warm to the touch.
Check to see if base of unit feels warm to the touch;
if so then warm mist is being produced.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
The humidity has a bad smell.
Hard water will deposit a certain amount of
dust. Dust in the air settles because of the
White dust is forming on
added humidity in the room.
nearby furniture.
*Use distilled water if this becomes a nuisance.
Or order a Decalcification Filter (FLtDc)
by calling 1.866.603.5900 or
visiting www.guardiantechnologies.com.
E-7