Velleman PCWSB1 Manual Del Usuario página 2

b. Receiver
c. Operation
1. Transmitter
• Connect the device to your computer by means of the enclosed USB cable and set the switch (p.1 #6) to USB
• OR connect the device to an audio source with the enclosed RCA cable, set the switch (p.1 #6) to "BATT/ ADAPTOR" and
insert 4 AA batteries (not incl.) in the battery compartment at the bottom
• OR connect the device to an audio source with the enclosed RCA cable, set the switch (p.1 #6) to "BATT/ ADAPTOR" and
connect the device to the mains by means of a 6V/100mA regulated power adapter (not incl.).
• Put the antenna upright, set the tuning wheel to the middle position and start the audio source.
2. Receiver
• Put 6 'C' batteries (not incl.) in the battery compartment at the bottom of the receiver or connect it to the mains by means of a
9V/1A regulated power supply (not incl.).
• Switch the receiver on (p.2 #3), the power/tuning indicator lights up.
• If it is green, the receiver should receive the signal ; set the volume control to the desired level.
• If it is red, search for the signal by means of the tuning button. If the power/tuning indicator turns from red to green, you have
found the signal ; set the volume control to the desired level
3. Fine-tuning
• For optimal tuning, transmitter and receiver should be approx. 15 feet apart.
• Pause the audio source and further tune the receiver so the background noise is reduced to a minimum.
• Put the receiver in the desired location, resume audio playback and adjust the receiver volume.
• Note: the longer the distance, the weaker the signal and the stronger the interference.
6. Troubleshooting
- Check if the transmitter is switched on (power indicator is lit)
- Check if the receiver is switched on and is receiving signal (power indicator is green)
no sound
- Check if the audio source is switched on and emitting signal (also check the cable)
- Check if the receiver volume control is not set to the minimum
- Check the condition of the batteries
- Check if the transmitter antenna is upright
interference, - Check if the audio source itself is clear and undistorted
distorted sound - Fine tune the receiver to reduce the background noise
- Check if the problem does not solve itself by changing the transmitter and/or receiver location
- Change the tuning setting of the transmitter and adjust the tuning of the receiver accordingly
The information in this manual is subject to change without prior notice.
PCWSB1
Front panel (left)
1. power/tuning indicator
2. volume control
3. power button
4. tuning wheel
Side panel (right)
5. headphones connector
6. 9Vdc power input
2 VELLEMAN