Side Mounting; Ceiling Mounting - Uline H-9045 Guia De Inicio Rapido

3. Feed excess wire into junction box and secure back
plate to junction box. (See Figure 1)
4. Snap in arrows on EXIT panel as required. Then snap
EXIT panel to housing: top first, then bottom. (See Figure 1)
NOTE: Use flexible conduit only. (See Figure 4)
Figure 4

SIDE MOUNTING

1. Attach crossbar to junction box. Set the crossbar so
longer blade is touching junction box. (See Figure 5)
Figure 5
Wire Nuts
Junction
Box
Crossbar
Crossbar Screws
(not included)
EXIT Panel
2. Open the EXIT housing. (See Figure 6) Feed the
transformer input leads through side hole, being sure to
secure wire into wire guides molded at edges of sign.
Figure 6
3. Attach sign to canopy by inserting canopy into sign at
an angle. Twist to secure. (See Figure 5)
4. Feed transformer input leads through center hole
and make the proper connections. (See Figures 2-3)
NOTE: If using 120VAC, connect black and white
leads to building utility.
NOTE: If using 277VAC, connect orange and
white leads to building utility.
NOTE: In some cases, not all leads will be used.
Cap off unused wire.
PAGE 2 OF 9
INSTALLATION CONTINUED
Plastic
Housing
Canopy
Back Plate
Diffuser
Snap-in
Directional Arrow
5. Feed excess wire into junction box and align holes in
canopy with holes in crossbar. Use screws supplied
to tighten canopy to crossbar so canopy is securely
fastened and tight against wall. (See Figure 5)
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first, then bottom.
NOTE: Use flexible conduit only. (See Figure 4)
7. Press test button to turn on LED heads. Adjust lamp
heads if needed. (See Figure 7)
Figure 7

CEILING MOUNTING

1. Attach crossbar to junction box. Set the crossbar so
the longer blade touches junction box.
(See Figure 8)
Figure 8
Junction Box
Crossbar
Canopy
Plastic Housing
EXIT Panel
2. Open the EXIT housing. (See Figure 6) Feed the
transformer input leads through top hole, being sure
to secure wire into wire guides molded at edges of
sign.
Diffuser
Snap-in
Directional Arrow
0221 IH-9045