Cooper Verdeon Instrucciones De Instalación página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions - Verdeon/VRDN
INSTALLATION
Tools Required
9/16" socket or wrench, screwdriver #2 Phillips and Flat,
electrical wiring tools as needed.
Installation Bird Guard
A splash guard is provided pre-cut to accommodate 1-5/8"
diameter mounting arms. When using larger diameter
mounting arms, remove the punch out section of the splash
guard (Figure 1).
Installation - 2 Bolt
1.
With housing lying on a smooth, soft surface open the
access door by releasing the side latches.
2.
The door may be removed by opening
approximately 120° and lifting off the hinge by
disconnecting two wire harness quick disconnects.
N
ote:
If optional lanyard is supplied, the door should not be
removed. (Figure 2.)
3.
Using a 9/16" socket, loosen the two pipe clamp
mounting bolts enough to allow mounting arm
(not included) to slide onto leveling steps. (Figure 2.)
4.
Lift the housing into place and position end of mounting
arm onto leveling steps so that housing is level. Care
must be taken so arm does not inadvertently strike
internal components. (Figure 2. & Figure 4.)
5.
Using a 9/16" socket tighten the two clamp mounting
bolts to 16-18 ft-lbs.
Installation - 4 Bolt
1.
With housing lying on a smooth, soft surface open the
access door by releasing the side latches.
2.
The door may be removed by opening
approximately 120° and lifting off the hinge by
disconnecting two wire harness quick disconnects.
N
ote:
If optional lanyard is supplied, the door should not be
removed. (Figure 3.)
N
ote:
Lanyard is not optional for Verd-M and is always
2 clamp. Need to ensure clamp or lanyard is not
removed.
3.
Using a 9/16" socket, loosen the four pipe clamp
mounting bolts enough to allow mounting arm
(not included) to slide onto leveling steps. (Figure 3.)
2
COOPER LIGHTING SOLUTIONS
IB521002EN
Installation instructions
Figure 1.
Bolts 3/8"-16
(2) Standard
(4) Optional
Angle Adjustment Stops
Figure 2.
(4) Bolts 3/8"-16
Figure 3.
Cutout for Larger
Diameter Arm
Securing Access Door
(2) Latches
Splash Guard
Pipe Clamp
(1) Standard
(2) Optional
Securing Access Door
(2) Latches
Splash Guard
(2) Pipe Clamps
Angle Adjustment Stops

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vrdn

Tabla de contenido